Powder coated steel, stainless steel or solid plastic toilet partitions - direct from Relcross Tel: 01380 729 600
 
   
Elite Powder Coated
Elite Stainless Steel
Elite Plus Powder Coated
Elite Plus Stainless Steel
Solid Plastic
Emperor - Corridor
Gladiator - Athletic
Replacement Front
  Locker Specifications

Standard Urinal Screens

 
 

CONSTRUCTION

Urinal screen panels and pilasters shall be constructed of two sheets of panel flatness zinc-coated steel, A446 Grade A, laminated under pressure to a honeycomb core for sound deadening and rigidity. Formed edges to be welded together and inter-locked under tension with a roll-formed oval-crown locking bar, mitered, welded and ground smooth at the corners. Honeycomb to have a maximum 25mm (1") cell size with compressive strength of 31 pounds per square inch.

WALL MOUNTED SCREEN

Panels shall be 25mm (1") thick with corner sheets not less than 22 gauge (0.8mm or .030"). The two cover sheets shall have edges sealed with a continuous oval-crown locking strip, mitered, welded and finished with a high-performance polymer powder coating. Corners shall be welded, ground smooth, and powder coated with finish to match locking strip. Screen must be 18" or 24" deep, and 42" high and anchored into wall approximately 12" off the floor with two brackets spaced 291/2" apart.

FLOOR MOUNTED SCREEN

Panels shall be 25mm (1") thick with cover sheets not less than 22 gauge (0.8mm or .030"). Supporting pilasters shall be 127mm (5") wide, 32mm (1.25") thick with cover sheets not less than 18 gauge (1.2mm or .048"). The two cover sheets shall have edges sealed with a continuous oval-crown locking strip, mitered, welded and finished with a high performance polymer powder coating. Corners shall be welded, ground smooth, and powder coated with finish to match locking strip. Pilasters shall be securely and rigidly fastened to the floor using 19mm (.75") diameter

expansion shield with spacer and nuts for leveling of pilasters. Floors, preferably concrete, should not be less than 127mm (5") thick for rigidity and anchorage. The floor fastening shall be concealed and protected by a 76mm (3") high, die-formed stainless steel pilaster shoe. Screen must be 58" high in varied depths and anchored approximately 12" off the floor with two brackets spaced 451/2" apart.

HARDWARE AND FITTING

All urinal screen panel and pilaster brackets shall be chrome plated zinc die castings.

FLANGE MOUNTED SCREEN

Panels shall be 25mm (1") thick with corner sheets not less than 22 gauge (0.8mm or .030"). The two cover sheet shall have edges sealed with a continuous oval-crown locking strip, mitered, welded and finished with a high performance polymer powder coating. Corners shall be welded, ground smooth, and powder coated with finish to match locking strip. Screen must be 18" or 24" deep, and 42" high. It shall be constructed of a one-piece 12 gauge full-length galvanized mounting backplate 4" wide and two pieces of full length angle brace 11/2" x 3" inserted and attached into the screen. It shall be attached to a concrete wall using 6 each 1/4" concrete rawl anchors to provide rigidity. (Not recommended for hollow wall installations).

FINISH

All sheet metal to be thoroughly cleaned, phosphated and finished with a high performance polymer coating, baked on to provide a uniform smooth protective finish. Color shall be selected from Hadrian's color chart.

 
 

 

 

 

 

 

hadrian manufacturing, inc.